LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> NX 300 Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System - Service Information >> Multi-Display >> Removal [09/2017 - 05/2019] >> Procedure

Removal [09/2017 - 05/2019]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Refer to PRECAUTION [09/2017 - 05/2019]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [09/2017 - 05/2019]

  3. REMOVE INSTRUMENT PANEL FINISH PLATE 

    Refer to PROCEDURE - Step 16

  4. REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET 
    1. for 8 inch:
      GTY777876Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 2 bolts.
      2. Move the multi-display assembly with bracket as indicated by the arrow shown in the illustration to detach the 2 clips.
        GTY777880Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Detach the 3 guides.
        GTY813382Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      4. Disconnect the 3 connector.
        GTY777884Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      5. Detach the clamp and remove the multi-display assembly with bracket.
    2. for 10.3 inch:
      GTY827888Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 2 bolts.
      2. Move the multi-display assembly with bracket as indicated by the arrow shown in the illustration to detach the 2 clips.
        GTY777877Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Detach the 3 guides.
        GTY813383Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      4. Disconnect the 3 connector.
        GTY827887Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      5. Detach the clamp and remove the multi-display assembly with bracket.
  5. REMOVE MULTI-DISPLAY CONTROLLER BRACKET A 
    1. for 8 inch:
      1. Remove the 2 screws.
        GTY777885Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Remove the 2 screws and multi-display controller bracket A.
        GTY827886Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for 10.3 inch:
      1. Remove the 2 screws.
        GTY775193Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Remove the 2 screws and multi-display controller bracket A.
        GTY775194Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE MULTI-DISPLAY ASSEMBLY 
scientia non olet · About LEMON Manuals