Installation [12/2017 - ]: Procedure

1. Install the front stabilizer bar with the 4 bolts.

   Torque: 120 N.m (1224 kgf/cm, 89 ft.lbf) 

   NOTE:

   Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of (B), (C), (D), and (A).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the front stabilizer link assembly LH to the lower No. 2 suspension arm assembly LH and front stabilizer bar with the 2 nuts.

   Torque: 150 N.m (1530 kgf/cm, 111 ft.lbf) 

   HINT: 

   If the ball joint turns together with the nut, use a 8 mm hexagon wrench to hold the stud bolt.

HINT: 

Perform the same procedure as for the LH side.

Refer to PROCEDURE - Step 179 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 179 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 180 [10/2020 - 10/2023] , or refer to PROCEDURE - Step 179 [10/2023 - ]

Refer to PROCEDURE - Step 180 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 180 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 181 [10/2020 - 10/2023] , or refer to PROCEDURE - Step 180 [10/2023 - ]

Refer to PROCEDURE - Step 181 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 181 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 182 [10/2020 - 10/2023] , or refer to PROCEDURE - Step 181 [10/2023 - ]

Refer to PROCEDURE - Step 183 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 183 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 184 [10/2020 - 10/2023] , or refer to PROCEDURE - Step 183 [10/2023 - ]

Refer to INSTALLATION [12/2017 - 10/2023] , or refer to INSTALLATION [10/2023 - ]