Installation [09/2023 - ]: Procedure

INSTALL FRONT STABILIZER BAR

Install the front stabilizer bar with the 4 bolts and 4 nuts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 120 N.m (1224 kgf/cm, 89 ft.lbf)

NOTE:

Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of (B), (C), (D), and (A).

INSTALL FRONT STABILIZER LINK ASSEMBLY LH
1. Install the front stabilizer link assembly LH to the lower No. 2 suspension arm assembly LH and front stabilizer bar with the 2 nuts.
  Torque: 125 N.m (1275 kgf/cm, 92 ft.lbf)
  
  HINT:
  
  If the ball joint turns together with the nut, use a 8 mm hexagon wrench to hold the stud bolt.
INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT:

Perform the same procedure as for the LH side.
INSTALL STRUT BAR BRACKET SUPPORT SUB-ASSEMBLY
Refer to PROCEDURE - Step 137
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 138
INSTALL FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY LH (w/ Front Suspension Member Brace)
Refer to PROCEDURE - Step 139
INSTALL FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY RH (w/ Front Suspension Member Brace)
Refer to PROCEDURE - Step 140
INSTALL FRONT FENDER SEAL LH (w/ Front Suspension Member Brace)
Refer to PROCEDURE - Step 18
INSTALL FRONT FENDER SEAL RH (w/ Front Suspension Member Brace)
Refer to PROCEDURE - Step 17
INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 143