LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Fuel System (A25A-FXS) - Service Information) >> Fuel Pressure Sensor >> Installation [06/2018 - ] >> Procedure

Installation [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL NO. 2 FUEL PRESSURE SENSOR 

    HINT: 

    Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.

    Refer to INITIALIZATION [06/2018 - 07/2019] , or refer to INITIALIZATION [07/2019 - 08/2020] , or refer to INITIALIZATION [08/2020 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]

    1. Install a new O-ring to the No. 2 fuel pressure sensor.
    2. Install the No. 2 fuel pressure sensor holder to the No. 2 fuel pressure sensor as shown in the illustration.
      GTY808669Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 No. 2 Fuel Pressure Sensor
      *2 No. 2 Fuel Pressure Sensor Holder
      *a Flat
    3. Using an 8 mm socket wrench, install the No. 2 fuel pressure sensor with the No. 2 fuel pressure sensor holder to the fuel delivery pipe sub-assembly with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    4. Connect the No. 2 fuel pressure sensor connector.
  2. TEMPORARILY INSTALL FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY 

    See step  1

  3. TEMPORARILY INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY 

    See step  7

  4. INSTALL FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY 

    See step  3

  5. INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY 

    See step  9

  6. CONNECT FUEL TUBE SUB-ASSEMBLY 

    See step  10

  7. INSTALL NO. 2 WATER BY-PASS PIPE 

    Refer to PROCEDURE - Step 6 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 6 [08/2021 - ]

  8. INSTALL EGR VALVE ASSEMBLY 

    Refer to INSTALLATION [06/2018 - 08/2021] , or refer to INSTALLATION [08/2021 - ]

  9. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY 

    Refer to INSTALLATION [06/2018 - ]

  10. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 2

  11. INSPECT FOR FUEL LEAK 

    Refer to PROCEDURE - Step 1

  12. PERFORM INITIALIZATION 
    1. Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.

      Refer to INITIALIZATION [06/2018 - 07/2019] , or refer to INITIALIZATION [07/2019 - 08/2020] , or refer to INITIALIZATION [08/2020 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]

scientia non olet · About LEMON Manuals