LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> RX 450h Base >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) (Service Information) (1 Of 2) >> REAR COMBINATION LIGHT ASSEMBLY (w/o Rear No. 2 Seat) >> Removal [10/2015 - 08/2016] >> Procedure

Removal [10/2015 - 08/2016]: Procedure

  1. REMOVE TONNEAU COVER ASSEMBLY 

    Refer to PROCEDURE - Step 1

  2. REMOVE DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 2

  3. REMOVE REAR NO. 3 FLOOR BOARD 

    Refer to PROCEDURE - Step 3

  4. REMOVE REAR DECK FLOOR BOX 

    Refer to PROCEDURE - Step 4

  5. REMOVE REAR NO. 4 FLOOR BOARD 

    Refer to PROCEDURE - Step 5

  6. REMOVE FRONT DECK FLOOR BOX (for LH Side) 

    Refer to PROCEDURE - Step 6

  7. REMOVE DECK SIDE TRIM BOX RH 

    Refer to PROCEDURE - Step 7

  8. REMOVE REAR FLOOR FINISH PLATE 

    Refer to PROCEDURE - Step 8

  9. REMOVE REAR DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 11

  10. REMOVE REAR SEAT ASSEMBLY LH (for LH Side) 

    Refer to REMOVAL [10/2015 - 08/2016]

  11. REMOVE REAR SEAT ASSEMBLY RH (for RH Side) 

    Refer to REMOVAL [10/2015 - 08/2016]

  12. REMOVE UPPER QUARTER TRIM PAD LH 

    Refer to PROCEDURE - Step 23

  13. REMOVE REAR SEAT SIDE GARNISH LH 

    Refer to PROCEDURE - Step 24

  14. REMOVE REAR FLOOR FINISH SIDE PLATE LH 

    Refer to PROCEDURE - Step 25

  15. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for LH Side) 

    Refer to PROCEDURE - Step 26

  16. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side) 

    Refer to PROCEDURE - Step 34

  17. REMOVE ROPE HOOK ASSEMBLY 

    Refer to PROCEDURE - Step 27

  18. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side) 

    Refer to PROCEDURE - Step 1

  19. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for RH Side) 

    Refer to PROCEDURE - Step 2

  20. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) 

    Refer to PROCEDURE - Step 29

  21. REMOVE RECLINING REMOTE CONTROL BEZEL RH (w/o Rear Power Seat System) 

    for RH Side:

    Refer to PROCEDURE - Step 37

  22. REMOVE FOLD SEAT SWITCH ASSEMBLY (w/ Rear Power Seat System) 

    for RH Side:

    Refer to PROCEDURE - Step 5

  23. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) 

    Refer to PROCEDURE - Step 39

  24. REMOVE REAR LIGHT COVER 
    1. Using a molding remover, disengage the 3 claws as shown in the illustration.
      GTY611718Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Insert Molding Remover Here
      Remove in this Direction
    2. Disengage the 3 claws and guide to remove the rear light cover as shown in the illustration.
      GTY826696Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  25. REMOVE REAR COMBINATION LIGHT ASSEMBLY 
    1. Disconnect the connector.
      GTY645871Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Apply protective tape around the rear combination light assembly as shown in the illustration.
      GTY647410Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    3. Remove the 2 screws.
      GTY645877Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the pin and 3 guides and separate the rear combination light assembly.
      NOTE:

      To prevent the rear combination light assembly from falling when disengaging the pin, lightly hold the rear combination light assembly.

      GTY660489Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Pin
      *b Guide
      Remove in this Direction
    5. Disengage the grommet to remove the rear combination light assembly.
      GTY646226Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals