Removal [05/2023 - ]: Procedure

REMOVE FRONT DOOR TRIM COVER SUB-ASSEMBLY LH (for Driver Side)
Refer to PROCEDURE - Step 4
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Driver Side)
Refer to PROCEDURE - Step 6
REMOVE FRONT DOOR ASSIST GRIP ASSEMBLY RH (for Front Passenger Side)
Refer to PROCEDURE - Step 8
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH (for Front Passenger Side)
Refer to PROCEDURE - Step 10
REMOVE NO. 1 SPEAKER ASSEMBLY WITH BOX
Refer to PROCEDURE - Step 5

REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Open

Detach the claw and open the wire harness protector.

Detach the clamp.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Open the front door glass sub-assembly LH fully open position.

Connect the No. 2 front door wire LH connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Insert the upper portion of the front door trim board sub-assembly LH into the front door panel to temporarily set it.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Temporarily Set in this Direction

Turn the engine switch on (IG).
For Driver Side:
1. Operate the multiplex network master switch assembly and set the front door glass sub-assembly LH to the fully open position.
For Front Passenger Side:
1. Operate the power window regulator switch assembly and set the front door glass sub-assembly RH to the fully open position.
Turn the engine switch off.

Lift up the front door trim board sub-assembly LH in the direction of the arrow and detach the guide.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove in this Direction

Disconnect the No. 2 front door wire LH connector.

Remove the 3 hole plugs.

Remove the 3 nuts.

NOTE:

Hold the outer rear view mirror assembly with one hand so that it does not drop.