Removal [08/2021 - ]: Procedure

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Refer to PRECAUTION [08/2015 - ]
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2021 - 08/2022] , or refer to INITIALIZATION [08/2022 - ]
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
Refer to PROCEDURE - Step 3
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 4
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 8
REMOVE FRONT UPPER CONSOLE PANEL GARNISH
Refer to PROCEDURE - Step 36
REMOVE RADIO RECEIVER ASSEMBLY WITH NAVIGATION ECU
Refer to PROCEDURE - Step 8
REMOVE NO. 1 RADIO BRACKET
Refer to PROCEDURE - Step 9
REMOVE NO. 2 RADIO BRACKET
Refer to PROCEDURE - Step 10

REMOVE NO. 1 NAVIGATION WIRE

Disconnect the 2 connectors and No. 1 navigation wire.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE RADIO RECEIVER BRACKET A

Remove the 5 screws and radio receiver bracket A.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE RADIO RECEIVER BRACKET B

Remove the 5 screws and radio receiver bracket B.