Removal [09/2015 - ]: Procedure

DISABLE AUTOAWAY/RETURN FUNCTION
1. Disable the autoaway/return function by changing the customize parameter (Refer to CUSTOMIZE PARAMETERS [09/2015 - ] .
  WARNING:
  Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.
  
  HINT:
  
  Performing the above operation causes the autoaway/return function to be disabled when the engine switch is turned off.
2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
3. Turn the engine switch off.
REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 1
REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
Refer to PROCEDURE - Step 2
REMOVE INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 13
REMOVE INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 25
REMOVE NO. 1 SWITCH HOLE BASE
Refer to PROCEDURE - Step 14
REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
See step 5
REMOVE INSTRUMENT PANEL MOULDING SUB-ASSEMBLY
Refer to PROCEDURE - Step 26
REMOVE CLOCK ASSEMBLY

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disconnect the connector.
2. Using a screwdriver, detach the 2 claws and remove the clock assembly.
  HINT:
  
  Tape the screwdriver tip before use.
  TEXT IN ILLUSTRATION
  
  * a Protective Tape