Installation [09/2015 - ]: Procedure
- INSTALL FLYWHEEL HOUSING SIDE COVER
- INSTALL STARTER ASSEMBLY
- Connect the starter connector.
- Connect the starter wire with the 2 nuts.
for nut A
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
for nut B
Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
- Close the terminal cap.
- Install the starter assembly with the 2 bolts.
Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)
NOTE:Make sure the flywheel housing side cover is as shown in the illustration.
- Connect the starter connector.
- INSTALL NO. 3 EXHAUST MANIFOLD HEAT INSULATOR
- Install the No. 3 exhaust manifold heat insulator with the 3 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Install the No. 3 exhaust manifold heat insulator with the 3 bolts.
- INSTALL FRONT NO. 2 ENGINE MOUNTING BRACKET RH
Refer to PROCEDURE - Step 54
- INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
(Refer to INSTALLATION [09/2015 - ] )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).
- INSTALL COWL TOP VENTILATOR LOUVER RH
Refer to PROCEDURE - Step 15