Removal [09/2015 - ]: Procedure

PRECAUTION
WARNING:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).
REMOVE COWL TOP VENTILATOR LOUVER RH
Refer to PROCEDURE - Step 1
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
Refer to PROCEDURE - Step 1
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 2
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
REMOVE NO. 3 BOX PANEL
Refer to PROCEDURE - Step 4
REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 5
REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL
Refer to PROCEDURE - Step 6
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 8
REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 9

REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

Remove the 2 bolts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Detach the 6 clips and pull out the multi-media module receiver assembly with bracket.
Disconnect the connectors and remove the multi-media module receiver assembly with bracket.

REMOVE NO. 2 RADIO BRACKET

Remove the 3 bolts and No. 2 radio bracket.

REMOVE NO. 1 RADIO BRACKET

Remove the 3 bolts and No. 1 radio bracket.