DTC P08CC-11: Shift Solenoid "J" Control Circuit Short to Ground [08/2015 - ]: Procedure

1. Disconnect the F78 ECM connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F78-45 (SC2) - Body ground	20°C (68°F)	11 to 15 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

See step  3

Result: 

OK 

See step  2

1. Replace the ECM.

   Refer to COMPONENTS [08/2015 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM A/T CODE REGISTRATION. Refer to  REGISTRATION [08/2015 - ] 

1. Disconnect the F73 transmission wire connector.
2. Disconnect the F78 ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F73-11 (SC2) or F78-45 (SC2) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR (TRANSMISSION WIRE - ECM) 

Result: 

OK 

See step  4

1. Remove the solenoid (SC2) valve.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Solenoid (SC2) Valve

   Refer to DISASSEMBLY [08/2015 - ]

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   Terminal of solenoid (SC2) valve connector - Solenoid (SC2) valve Body	20°C (68°F)	11 to 15 Ω

3. Connect a positive (+) lead from the battery to the terminal of the solenoid valve connector, and a negative (-) lead to the solenoid body. Check that the valve moves and makes an operating sound.

   OK

   Valve moves and makes an operating sound.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPAIR OR REPLACE TRANSMISSION WIRE. Refer to  COMPONENTS [08/2015 - ] 

Result: 

NG 

REPLACE SOLENOID (SC2) VALVE. Refer to  COMPONENTS [08/2015 - 10/2016]  , or refer to  COMPONENTS [10/2016 - ]