DTC P107A-15: Fuel Rail Pressure Sensor (Low) Circuit Short to Battery or Open [09/2020 - 09/2022]: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR (FUEL PRESSURE SENSOR (FOR LOW PRESSURE SIDE) - ECM)
- Disconnect the fuel pressure sensor (for low pressure side) connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition F92-2 (PFL) - F78-102 (PFL) Always Below 1 Ω F92-3 (E2) - F78-133 (EPFL) Always Below 1 Ω F92-2 (PFL) or F78-102 (PFL) - Other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 2
- CHECK TERMINAL VOLTAGE (POWER SOURCE OF FUEL PRESSURE SENSOR (FOR LOW PRESSURE SIDE))
*a Front view of wire harness connector
(to Fuel Pressure Sensor (for Low Pressure Side))- Disconnect the fuel pressure sensor (for low pressure side) connector.
- Turn the engine switch on (IG).
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition F92-1 (VC) - F92-3 (E2) Engine switch on (IG) 4.75 to 5.25 V Result
Proceed to OK NG HINT:
Perform "Inspection After Repair" after replacing the fuel pressure sensor (for low pressure side).
Refer to INITIALIZATION [09/2019 - ]
Result:
OK
REPLACE FUEL DELIVERY PIPE (FUEL PRESSURE SENSOR (FOR LOW PRESSURE SIDE)). Refer to REMOVAL [08/2015 - ]
Result:
NG
REPLACE ECM. Refer to REMOVAL [08/2015 - ]