DTC P0711: Transmission Fluid Temperature Sensor "A" Performance [04/2013 - 08/2015]: Procedure
WARNING: This page is about a different car, the 2015 Lexus IS 250 and 2014 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) position and push the Techstream main switch ON.
- When you use Techstream: Select the item "Powertrain / Engine and ECT / Trouble Codes".
Powertrain > Engine > Trouble Codes
- Read the DTCs using the Techstream.
Result
Result Proceed to Only DTC P0711 is output A P0711 and other DTCs are output B HINT:
If any DTCs other than P0711 are output, perform troubleshooting for those DTCs first.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [04/2013 - 06/2014] , or refer to DIAGNOSTIC TROUBLE CODE CHART [06/2014 - 08/2015]
Result:
A
See step 2
- INSPECT AUTOMATIC TRANSMISSION FLUID LEVEL
OK
Automatic transmission fluid level is correct.
Result
Proceed to OK NG Result:
OK
REPAIR OR REPLACE TRANSMISSION WIRE. Refer to COMPONENTS [04/2013 - 08/2015]
Result:
NG
ADJUST AUTOMATIC TRANSMISSION FLUID LEVEL. Refer to ADJUSTMENT [04/2013 - 08/2015]