DTC P2807-13: Pressure Control Solenoid "G" Circuit Open [10/2017 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus IS 350, 2023 Lexus IS 350, 2022 Lexus IS 350, 2021 Lexus IS 350, and 2020 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL4) - ECM)
- Disconnect the F102 ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition F102-12 (SL4+) - F102-13 (SL4-) 20°C (68°F) 5.0 to 5.6 Ω F102-12 (SL4+) or F102-13 (SL4-) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
See step 3
Result:
OK
See step 2
- REPLACE ECM
- Replace the ECM.
Refer to COMPONENTS [10/2017 - ]
Result
Proceed to NEXT
Result:
NEXT
PERFORM A/T CODE REGISTRATION. Refer to REGISTRATION [10/2017 - ]
- Replace the ECM.
- CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM)
- Disconnect the F73 transmission wire connector.
- Disconnect the F102 ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition F73-15 (SL4+) - F102-12 (SL4+) Always Below 1 Ω F73-16 (SL4-) - F102-13 (SL4-) Always Below 1 Ω F73-15 (SL4+) or F102-12 (SL4+) - Body ground Always 10 kΩ or higher F73-16 (SL4-) or F102-13 (SL4-) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 4
- INSPECT SHIFT SOLENOID VALVE SL4
- Remove the shift solenoid valve SL4.
*1 Shift Solenoid Valve SL4 Refer to DISASSEMBLY [04/2013 - ]
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Terminal 1 of the shift solenoid valve SL4 - terminal 2 20°C (68°F) 5.0 to 5.6 Ω - Connect a positive (+) lead from the battery with a 21 W bulb to terminal 1 and a negative (-) lead to terminal 2 of the shift solenoid valve connector. Check that the valve moves and makes an operating sound.
OK
Valve moves and makes an operating sound.
Result
Proceed to OK NG
Result:
OK
REPAIR OR REPLACE TRANSMISSION WIRE. Refer to COMPONENTS [04/2013 - ]
Result:
NG
REPLACE SHIFT SOLENOID VALVE SL4. Refer to COMPONENTS [10/2016 - ]
- Remove the shift solenoid valve SL4.