LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> GS 200t Base >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning System - Service Information >> Air Conditioning Panel >> Removal [09/2014 - 09/2017] >> Procedure

Removal [09/2014 - 09/2017]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2014 - 10/2015] or PRECAUTION [10/2015 - ] ).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2014 - 10/2015] or INITIALIZATION [10/2015 - ] ).

  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 1

  4. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY 
    1. Remove the 2 bolts.
      GTY530893Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the 2 claws and 2 clips.
      GTY537498Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Pull out the multi-media module receiver assembly.
    4. Disconnect the connectors and remove the multi-media module receiver assembly.
  5. REMOVE ANTENNA DIVIDER (w/ Satellite Radio) 

    Refer to PROCEDURE - Step 10 (09/2014 - 10/2015) or PROCEDURE - Step 10 (10/2015 -)

  6. REMOVE NO. 1 RADIO BRACKET 
    GTY531023Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 3 screws and No. 1 radio bracket.
  7. REMOVE NO. 2 RADIO BRACKET 
    GTY531725Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 3 screws and No. 2 radio bracket.
scientia non olet · About LEMON Manuals