LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2016 >> LS 600h >> Repair and Diagnosis >> Accessories & Equipment >> Warning Systems >> Vehicle Proximity Notification System - Service Information >> Vehicle Approaching Speaker Ecu >> Removal [09/2015 - ] >> Procedure

Removal [09/2015 - ]: Procedure

  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3

  2. REMOVE BATTERY SERVICE HOLE COVER LH 

    Refer to PROCEDURE - Step 4

  3. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).

  5. REMOVE INSTRUMENT SIDE PANEL RH 

    Refer to PROCEDURE - Step 17

  6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 19

  7. REMOVE INSTRUMENT PANEL FINISH END PANEL RH 

    Refer to PROCEDURE - Step 2

  8. REMOVE LOWER INSTRUMENT PANEL 

    Refer to PROCEDURE - Step 8

  9. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIR BAG ASSEMBLY 

    Refer to PROCEDURE - Step 9

  10. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY 

    Refer to PROCEDURE - Step 22

  11. REMOVE VEHICLE APPROACHING SPEAKER CONTROLLER 
    GTY403875Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the connector.
    2. Remove the screw and vehicle approaching speaker controller.
scientia non olet · About LEMON Manuals