LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2016 >> LS 600h >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System - Service Information >> Multi-Display >> Removal [09/2015 - ] >> Procedure

Removal [09/2015 - ]: Procedure

  1. PRECAUTION 
    WARNING:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3

  3. REMOVE BATTERY SERVICE HOLE COVER LH 

    Refer to PROCEDURE - Step 4

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).

  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH 

    Refer to PROCEDURE - Step 1

  6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH 

    Refer to PROCEDURE - Step 2

  7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3

  8. REMOVE NO. 3 BOX PANEL 

    Refer to PROCEDURE - Step 4

  9. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 5

  10. REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 6

  11. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7

  12. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 8

  13. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 9

  14. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY 

    Refer to PROCEDURE - Step 15

  15. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY 

    Refer to PROCEDURE - Step 18

  16. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 23

  17. REMOVE ACCESSORY METER ASSEMBLY 
    1. Remove the 4 bolts.
      GTY399675Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Move the accessory meter assembly in the direction of the arrow in the illustration.
      GTY399674Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect all the connectors and detach the clamp.
    4. Remove the accessory meter assembly.
  18. REMOVE NO. 1 COMBINATION METER BRACKET 
    1. Remove the 2 bolts and No. 1 combination meter bracket.
      GTY399669Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals