Removal [09/2015 - ]: Procedure
- PRECAUTION WARNING:
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).
NOTE:- When replacing the multi-media module receiver assembly or DCM (telematics transceiver), perform the vehicle contract setting (Refer to DCM ACTIVATION [09/2015 - ] ).
- The safety connect device uses the DCM (telematics transceiver) to provide access to the network service.
- The DCM (telematics transceiver) has a DCM ID (described on the label attached to the DCM (telematics transceiver)).
- REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
- REMOVE BATTERY SERVICE HOLE COVER LH
Refer to PROCEDURE - Step 4
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL WARNING:
Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).
- REMOVE INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 2
- REMOVE INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 17
- REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 19
- REMOVE LOWER INSTRUMENT PANEL
Refer to PROCEDURE - Step 8
- REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 9
- REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
Refer to PROCEDURE - Step 22
- REMOVE DCM (TELEMATICS TRANSCEIVER)
- REMOVE NO. 1 TELEPHONE BRACKET
- REMOVE NO. 2 TELEPHONE BRACKET