LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2016 >> LS 600h >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Service Information >> Combination Meter >> Removal [09/2015 - ] >> Procedure

Removal [09/2015 - ]: Procedure

  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3

  2. REMOVE BATTERY SERVICE HOLE COVER LH 

    Refer to PROCEDURE - Step 4

  3. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).

  4. DISABLE AUTOAWAY/RETURN FUNCTION 
    1. Disable the autoaway/return function by changing the customize parameter (Refer to CUSTOMIZE PARAMETERS [09/2015 - ] ).
      NOTE:

      Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      HINT: 

      Performing the above operation causes the autoaway/return function to be disabled when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully retract and tilt up the steering column assembly.
    3. Turn the power switch off.
  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    1. Disconnect the cable from the auxiliary battery negative (-) terminal.
      WARNING:

      Wait at least 90 seconds after disconnecting the cable from the auxiliary negative (-) battery terminal to disable the SRS system.

      NOTE:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).

  6. REMOVE INSTRUMENT SIDE PANEL LH 

    Refer to PROCEDURE - Step 7

  7. REMOVE INSTRUMENT PANEL ORNAMENT 

    Refer to PROCEDURE - Step 8

  8. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 9

  9. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 
    1. Apply protective tape to the area shown in the illustration.
      TEXT IN ILLUSTRATION

      *1 Protective Tape
      GTY418035Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 clips.
    3. Detach the 6 clips and remove the instrument finish panel sub-assembly.
    4. Disconnect the 2 connectors.
  10. REMOVE STEERING COLUMN COVER (w/o Driver Monitor Camera) 

    Refer to PROCEDURE - Step 6

  11. REMOVE STEERING COLUMN COVER (w/ Driver Monitor Camera) 

    Refer to PROCEDURE - Step 7

  12. REMOVE COMBINATION METER ASSEMBLY 
    1. Remove the 4 screws and combination meter assembly.
      GTY406541Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the 2 claws and open the connector cover.
      GTY406540Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the connector.
scientia non olet · About LEMON Manuals