Installation [08/2015 - ]: Procedure

INSTALL VANE PUMP ASSEMBLY
1. Install the vane pump with the 2 bolts.
  Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
CONNECT PRESSURE FEED TUBE
1. Install a new gasket to the pressure feed tube.
2. Connect the pressure feed tube and install the union bolt.
  Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf)
  
  HINT:
  
  Make sure the stopper of the pressure feed tube touches the vane pump.
CONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR
1. Connect the connector.
CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
1. Connect the No. 1 oil reservoir to pump hose to the vane pump assembly with the clip.
INSTALL FAN AND GENERATOR V BELT
Refer to PROCEDURE - Step 1
INSTALL RADIATOR SUPPORT UPPER SEAL
Refer to PROCEDURE - Step 81 [08/2015 - 08/2020] , or refer to PROCEDURE - Step 81 [08/2020 - ]
INSTALL AIR CLEANER CASE
Refer to PROCEDURE - Step 51 [08/2015 - 08/2020] , or refer to PROCEDURE - Step 51 [08/2020 - ]
INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
INSTALL AIR CLEANER CAP AND HOSE
Refer to PROCEDURE - Step 53 [08/2015 - 08/2020] , or refer to PROCEDURE - Step 53 [08/2020 - ]
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 80 [08/2015 - 08/2020] , or refer to PROCEDURE - Step 80 [08/2020 - ]
INSTALL FRONT FENDER APRON SEAL RH
Refer to PROCEDURE - Step 84 [08/2015 - 08/2020] , or refer to PROCEDURE - Step 84 [08/2020 - ]
INSTALL FRONT WHEEL RH
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2021] , or refer to INITIALIZATION [08/2021 - 08/2022] , or refer to INITIALIZATION [08/2022 - ] ).
ADD POWER STEERING FLUID
BLEED POWER STEERING FLUID
See step 2
INSPECT FOR POWER STEERING FLUID LEAK