Installation [08/2015 - ]: Procedure

1. Set the fan and generator V belt onto every part.
   Fig 1: Engine Drive Belt Routing Diagram

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   TEXT IN ILLUSTRATION
   
   

   Callout	Description
   *1	Water Pump Pulley
   *2	Fan Pulley
   *3	No. 1 Idler Pulley
   *4	Vane Pump Pulley
   *5	Generator Pulley
   *6	V-ribbed Belt Tensioner
   *7	Crankshaft Pulley
   *8	Cooler Compressor Pulley

2. While turning the belt tensioner counterclockwise, remove the pin.
   NOTE:

   Make sure that the fan and generator V belt is properly set on each pulley.

3. Check that the belt fits properly in the ribbed grooves.

   HINT: 

   Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

See step  81[08/2015 - 08/2020], or see step  81 [08/2020 - ]

See step  80[08/2015 - 08/2020], or see step  80 [08/2020 - ]