Removal [08/2015 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE CENTER NO. 4 ENGINE UNDER COVER
Refer to PROCEDURE - Step 1
DRAIN ENGINE COOLANT
Refer to PROCEDURE - Step 2
REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 3 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 3 [10/2016 - 09/2020] , or refer to PROCEDURE - Step 3 [09/2020 - ]
REMOVE AIR CLEANER HOSE ASSEMBLY
Refer to PROCEDURE - Step 4

REMOVE ENGINE COOLANT TEMPERATURE SENSOR

Disconnect the engine coolant temperature sensor connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using SST, remove the engine coolant temperature sensor from water outlet sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Gasket

SST: 09817-33191

NOTE:

If the engine coolant temperature sensor has been struck or dropped, replace it.

Remove the gasket from the engine coolant temperature sensor.