LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> IS 350 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Engine Cooling System (2GR-FKS) - Service Information) >> Thermostat >> Installation [10/2017 - ] >> Procedure

Installation [10/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 350, 2023 Lexus IS 300, and 2022 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 
    1. Install a new gasket to the water inlet with thermostat sub-assembly.
    2. Install the water inlet with thermostat sub-assembly to the timing chain cover assembly with the 2 bolts and nut.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

    3. Connect the No. 15 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.
    4. Connect the No. 3 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.
    5. Connect the water inlet with thermostat sub-assembly connector.
  2. CONNECT NO. 2 RADIATOR HOSE SUB-ASSEMBLY 
    1. Connect the No. 2 radiator hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.
  3. ADD ENGINE COOLANT 

    See step  3

  4. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  5. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 104 [10/2017 - 09/2020] , or refer to PROCEDURE - Step 104 [09/2020 - ]

scientia non olet · About LEMON Manuals