Installation [08/2015 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL OIL PRESSURE SWITCHING VALVE ASSEMBLY
- Apply a light coat of engine oil to the O-ring of the oil pressure switching valve assembly.
*1 O-Ring - Install the oil pressure switching valve assembly to the water inlet housing with the bolt.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
NOTE:- When reusing the oil pressure switching valve assembly, inspect the O-ring.
- Make sure that the O-ring is not cracked or jammed when installing the oil pressure switching valve assembly.
- Apply a light coat of engine oil to the O-ring of the oil pressure switching valve assembly.
- INSTALL WATER BY-PASS PIPE ASSEMBLY
Refer to PROCEDURE - Step 4
- INSTALL NO. 3 EXHAUST MANIFOLD HEAT INSULATOR
Refer to PROCEDURE - Step 5
- INSTALL TURBOCHARGER SUB-ASSEMBLY
Refer to INSTALLATION [08/2015 - ]
- INSPECT FOR ENGINE OIL LEAK
See step 5 [08/2015 - 09/2020], or see step 5 [09/2020 - 11/2021], or see step 5 [11/2021 - 09/2022], or see step 5 [09/2022 - ]