LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> IS 350 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Charging System (2UR-GSE) - Service Information) >> Generator >> Installation [11/2021 - ] >> Procedure

Installation [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus IS 500, 2023 Lexus IS 500, and 2022 Lexus IS 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL GENERATOR ASSEMBLY 
    1. Using an E8 "TORX" socket wrench, temporarily install the generator assembly with the 2 stud bolts.
    2. Tighten the 2 stud bolts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

    3. Install the generator assembly and engine wire bracket with the 2 bolts and 2 nuts.

      Torque: 43 N.m (438 kgf/cm, 32 ft.lbf) 

    4. Connect the oil cooler tube with the bolt.

      Torque: 6.0 N.m (61 kgf/cm, 53 in.lbf) 

    5. Connect the generator assembly connector.
    6. Connect the engine wire to terminal B with the nut.

      Torque: 12 N.m (122 kgf/cm, 9 ft.lbf) 

    7. Close the terminal cap.
    8. Connect the engine wire with the bolt.

      Torque: 21 N.m (214 kgf/cm, 15 ft.lbf) 

    9. Engage the clamp.
  2. CONNECT NO. 2 RADIATOR HOSE 

    Refer to PROCEDURE - Step 9

  3. INSTALL V-RIBBED BELT 

    Refer to INSTALLATION [11/2021 - ]

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [11/2021 - 09/2022] , or refer to INITIALIZATION [09/2022 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]

  5. ADD ENGINE COOLANT 

    Refer to PROCEDURE - Step 4

  6. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  7. INSTALL ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 89

  8. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 2

scientia non olet · About LEMON Manuals