Installation [04/2013 - 08/2015]: Procedure

1. Using SST, install a new rear No. 1 differential mount cushion.
   • SST: 09527-1701109570-24011 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *A	for 2GR-FSE	*B	for 4GR-FSE
   *a	0° +/- 3°	-	-
   	SST bolt location		Front of the Vehicle

   NOTE:

   • Make sure that the rear No. 1 differential mount cushion is aligned within 3° from the center.
   • Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.
   • Before using SST, apply grease to the SST bolts.
   • Be sure to use the correct combination of SST.
   • Make sure that SST (09527-17011) contacts the entire circumference of the rear No. 1 differential mount cushion.
   • Do not tilt the bolts of SST.
   • Tighten the 2 bolts of SST so that they enter the 2 holes of the rear No. 1 differential mount cushion by an equal amount.

   HINT: 

   Install the 2 SST bolts to the 2 SST holes as shown in the illustration.

1. Using SST, install a new rear No. 2 differential mount cushion.
   • SST: 09527-1701109570-24011 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *A	for 2GR-FSE	*B	for 4GR-FSE
   *a	0° +/- 3°	-	-
   	SST bolt location		Front of the Vehicle

   NOTE:

   • Make sure that the rear No. 2 differential mount cushion is aligned within 3° from the center.
   • Temporarily install the rear No. 2 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.
   • Before using SST, apply grease to the SST bolt.
   • Be sure to use the correct combination of SST.
   • Make sure that SST (09527-17011) contacts the entire circumference of the rear No. 2 differential mount cushion.
   • Do not tilt the bolt of SST.

   HINT: 

   Install the SST bolt to the SST hole as shown in the illustration.

Refer to PROCEDURE - Step 16