LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2011 >> RX 350 AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) (Service Information) >> Rear Light Assembly >> Removal >> Removal

Rear Light Assembly: Removal: Removal

  1. REMOVE TONNEAU COVER SUB-ASSEMBLY 
  2. REMOVE BACK DOOR FINISH COVER LH (w/o Power Back Door)  . Refer to DISASSEMBLY - Step 3
  3. REMOVE BACK DOOR TRIM BASE (w/ Power Back Door)  . Refer to DISASSEMBLY - Step 4
  4. REMOVE BACK DOOR FINISH COVER RH (w/o Power Back Door)  . Refer to DISASSEMBLY - Step 5
  5. REMOVE DOOR PULL HANDLE WITH SWITCH (w/ Power Back Door)  . Refer to DISASSEMBLY - Step 6
  6. REMOVE BACK DOOR LOCK COVER  . Refer to DISASSEMBLY - Step 7
  7. REMOVE NO. 2 ROOM LIGHT ASSEMBLY  . Refer to REMOVAL - Step 2
  8. REMOVE BACK DOOR UPPER TRIM COVER LH  . Refer to DISASSEMBLY - Step 9
  9. REMOVE BACK DOOR UPPER TRIM COVER RH  . Refer to DISASSEMBLY - Step 10
  10. REMOVE BACK DOOR SERVICE HOLE COVER LH  . Refer to DISASSEMBLY - Step 11
  11. REMOVE BACK DOOR SERVICE HOLE COVER RH  . Refer to DISASSEMBLY - Step 12
  12. REMOVE BACK DOOR TRIM PANEL ASSEMBLY  . Refer to DISASSEMBLY - Step 13
  13. REMOVE POWER BACK DOOR TOUCH SENSOR ASSEMBLY (w/ Power Back Door)  . Refer to REMOVAL - Step 11
  14. REMOVE REAR LIGHT ASSEMBLY 
    1. Disconnect each connector.
      Fig 1: Identifying 4 Nuts
      GTY268814Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 4 nuts and rear light assembly.
scientia non olet · About LEMON Manuals