LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> RX 400h FWD >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel >> Instrument Panel Safety Pad >> Installation

Instrument Panel Safety Pad: Installation

  1. INSTALL INSTRUMENT PANEL ASSEMBLY 
    1. Connect each of the clamps and connectors.
      Fig 1: Identifying Speaker Hole No.1 Cover Clips
      G05274394Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the 2 bolts < A >, bolt < B > and 2 nuts < D > as shown in the illustration below, then install the instrument panel assembly.
      Fig 2: Identifying Instrument Panel Connector And Clips
      G05281250Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) (Bolt < B >) 

  2. INSTALL INSTRUMENT PANEL NO.1 REGISTER ASSEMBLY LOWER 
    1. Engage the 3 clips and 2 claws, and install the instrument panel No.1 register assembly lower.
      Fig 3: Identifying Instrument Panel No.1 Register Assembly Lower Clips And Claws
      G05274422Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL INSTRUMENT PANEL NO.1 REGISTER ASSEMBLY 
    1. Engage the 2 clips and 2 claws.
    2. Install the screw < C >, nut < D >, and the instrument panel No.1 register assembly.
  4. INSTALL INSTRUMENT PANEL FINISH PLATE 
  5. INSTALL FRONT PILLAR GARNISH LH  (See INSTALLATION )
  6. INSTALL FRONT PILLAR GARNISH RH 

    HINT:

    Use the same procedures for the RH side and the LH side.

    Fig 4: Identifying Instrument Panel No.1 Register Assembly Clips And Claws
    G05274423Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER 
    1. Engage the 2 clips.
    2. Install the 7 screws < C > and the instrument panel finish panel lower center.
      Fig 5: Identifying Instrument Panel Finish Panel Lower Center Screws
      G05274390Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. INSTALL FLOOR CARPET COVER CENTER LH 
    1. Slide the floor carpet cover center LH to the rear of the vehicle, and engage the 2 claws to the instrument panel finish panel lower center at the floor carpet cover center LH.
    2. Install the 2 clips and the floor carpet cover center LH.
  9. INSTALL FLOOR CARPET COVER CENTER RH 

    HINT:

    Use the same procedures for the RH side and the LH side.

    Fig 6: Installing Floor Carpet Cover Center RH
    G05274425Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY 
    1. Connect the connector.
    2. Install the 2 bolts < A >, the 2 screws < C >, and the glove compartment door assembly.
      Fig 7: Identifying Glove Compartment Door Screws
      G05274388Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. INSTALL INSTRUMENT PANEL N0.2 UNDER COVER SUB-ASSEMBLY 
    1. Connect the connectors.
    2. Engage the 3 claws and install the instrument panel No.2 under cover sub-assembly.
  12. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH 

    HINT:

    Use the same procedures for the RH side and the LH side.

    Fig 8: Identifying Instrument Panel No.2 Under Cover Claws
    G05274427Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. INSTALL FRONT DOOR SCUFF PLATE RH 

    HINT:

    Use the same procedures for the RH side and the LH side.

  14. INSTALL COMBINATION METER ASSEMBLY 
    1. Connect the connectors.
    2. Install the 4 screws < C > and the combination meter assembly.
      Fig 9: Identifying Combination Meter Assembly Screws
      G05274386Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 
    1. Engage the 4 clips and install the instrument cluster finish panel sub-assembly.
      2. Fig 10: Identifying Clips On Instrument Cluster Finish Panel Sub-Assembly
      G05274429Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY  (See INSTALLATION )
  17. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER 
    1. Connect the connectors.
    2. Engage the 5 claws and the 4 clips.
    3. Connect the hood lock control cable assembly.
    4. Install the bolt < A >, the screw < C >, and the instrument panel finish panel sub-assembly lower.
      Fig 11: Installing Instrument Panel Finish Panel Sub-Assembly Lower
      G05274430Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  18. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH 
    1. Install the 2 clips and the cowl side trim sub-assembly LH.
    Fig 12: Identifying Clips On Cowl Side Trim Sub-Assembly LH
    G05274383Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  19. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  20. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPARAL CABLE SUB-ASSEMBLY  (See INSTALLATION )
  21. INSTALL TILT AND TELESCOPIC SWITCH (w/ Power Tilt and Power Telescopic)  (See INSTALLATION )
  22. INSTALL STEERING COLUMN COVER  (See INSTALLATION )
  23. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  24. INSTALL STEERING PAD  (See INSTALLATION )
  25. INSTALL STEERING WHEEL NO.3 COVER LOWER  (See INSTALLATION )
  26. INSTALL STEERING WHEEL NO.2 COVER LOWER  (See INSTALLATION )
  27. INSTALL MULTI-DISPLAY (w/ Navigation System)  (See INSTALLATION )
  28. INSTALL CENTER CLUSTER INTEGRATION SWITCH (w/o Navigation System)  (See INSTALLATION )
  29. INSTALL RADIO RECEIVER  (See INSTALLATION )
  30. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER 
    1. Connect the connectors.
    2. Engage the 2 clips and install the instrument panel finish panel lower.
      Fig 13: Identifying Clips On Instrument Panel Finish Panel Lower
      G05274382Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  31. INSTALL CONSOLE PANEL UPPER FRONT 
    1. Engage the 4 clips and install the console panel upper front.
      2. Fig 14: Identifying Clips On Console Panel Upper Front
      G05274381Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  32. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY 
  33. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  34. PERFORM INITIALIZATION 
    NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal (See INITIALIZATION ).
  35. INSPECT STEERING PAD  (See INSTALLATION )
  36. INSPECT SRS WARNING LIGHT 

    (See DIAGNOSIS SYSTEM )

scientia non olet · About LEMON Manuals