LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> RX 400h FWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation >> Navigation Ecu >> Removal

Navigation Ecu: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE DECK BOARD SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE TONNEAU COVER ASSEMBLY 
  4. REMOVE JACK CARRIER ASSEMBLY  (See REMOVAL )
  5. REMOVE FRONT DECK FLOOR BOX  (See REMOVAL )
  6. REMOVE REAR DECK FLOOR BOX  (See REMOVAL )
  7. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY  (See REMOVAL )
  8. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY  (See REMOVAL )
  9. REMOVE REAR FLOOR FINISH PLATE  (See REMOVAL )
  10. REMOVE SIDE DECK TRIM BOX LH  (See REMOVAL )
  11. REMOVE SIDE DECK TRIM BOX RH 
  12. REMOVE NAVIGATION ECU 
    1. Disconnect each connector.
    2. Remove the 3 nuts and the navigation ECU.
      Fig 1: Locating Navigation ECU Nuts
      G05271017Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE DISC PLAYER BRACKET 
    1. Remove the 2 screws and the disc player bracket.
      Fig 2: Locating Disc Player Bracket Screws
      G05271019Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE NO. 2 DISC PLAYER BRACKET 
    1. Remove the 2 screws and the No. 2 disc player bracket.
      Fig 3: Locating No. 2 Disc Player Bracket Screws
      G05271018Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals