Driver Side Knee Airbag Assembly: Installation

INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
1. Install the driver side knee airbag assembly with the 4 bolts.
  Torque: 7.6 N*m (78 kgf*cm, 68 in.*lbf)
2. Connect the connector to the driver side knee airbag assembly.
  NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
  
  Fig 1: Identifying Driver Side Knee Airbag Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).