Installation

DOOR / HATCH: POWER BACK DOOR MAIN SWITCH: INSTALLATION

1. INSTALL POWER BACK DOOR MAIN SWITCH






(a) Attach the 2 claws to install the switch.
2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Installation

3. INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH Installation

4. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH Installation

5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

6. INSTALL NO. 1 SWITCH HOLE BASE Installation

7. INSTALL INSTRUMENT SIDE PANEL LH Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

9. INSTALL ENGINE ROOM SIDE COVER LH Removal

10. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.