Removal

PARK ASSIST / MONITORING: CLEARANCE WARNING BUZZER: REMOVAL

1. REMOVE ENGINE ROOM SIDE COVER LH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
- w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE INSTRUMENT SIDE PANEL LH Removal

4. REMOVE NO. 1 SWITCH HOLE BASE Removal

5. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH Removal

6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

7. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Removal

8. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY Removal







9. REMOVE NO. 1 CLEARANCE WARNING BUZZER
(a) Disconnect the connector.
(b) Using a clip remover, detach the clip and remove the No. 1 clearance warning buzzer.