Clutch Accumulator: Installation

WARNING: This page is about a different variant/trim than selected.

TEMPORARILY TIGHTEN CLUTCH ACCUMULATOR ASSEMBLY
1. Temporarily tighten the clutch accumulator with the 2 bolts.
  
  Fig 1: Locating Clutch Accumulator Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CLUTCH TUBE
1. Using SST, connect the clutch tube.
  SST 09023-12701
  
  Torque: When using SST
  
  21 N*m (216 kgf*cm, 16 ft.*lbf)
  
  When not using SST
  
  23 N*m (235 kgf*cm, 17 ft.*lbf)
  
  HINT:
  
  Use a torque wrench with a fulcrum length of 345 mm (13.58 in.).
  
  Fig 2: Identifying Fulcrum Length Of 345 mm
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the clutch tube to the bracket with a new clip.
3. Using SST, connect the clutch tube.
  SST 09023-00101
  
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
  
  HINT:
  
  Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
  
  Fig 3: Identifying Fulcrum Length Of 300 mm
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CLUTCH LINE
1. Using SST, connect the clutch line.
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
  
  HINT:
  
  Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
2. Temporarily tighten the clutch line with the bolt.
  
  Fig 4: Identifying Fulcrum Length Of 300 Mm
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FULLY TIGHTEN CLUTCH ACCUMULATOR ASSEMBLY
1. Fully tighten the clutch accumulator with the 3 bolts.
  Torque: 12 N*m (120 kgf*cm, 9 ft.*lbf)
  
  Fig 5: Locating Clutch Accumulator Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
BLEED CLUTCH LINE
1. Fill the brake reservoir with the brake fluid and bleed the clutch system (See BLEEDING ).
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
CHECK FOR BRAKE FLUID LEAKAGE
1. Check for leakage in the clutch system.
CHECK FOR BRAKE FLUID LEVEL IN RESERVOIR