LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (UF1AE Transfer Case) >> Transfer Control Solenoid >> Removal

Transfer Control Solenoid: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DRAIN AUTOMATIC TRANSMISSION FLUID  (See REMOVAL )
  2. REMOVE REAR NO. 1 FLOOR PANEL BRACE  (See REMOVAL )
  3. REMOVE FRONT CENTER FLOOR BRACE  (See REMOVAL )
  4. DISCONNECT HEATED OXYGEN SENSOR  (See REMOVAL )
  5. REMOVE FRONT EXHAUST PIPE ASSEMBLY  (See REMOVAL )
  6. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR  (See REMOVAL )
  7. SUPPORT AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY  (See REMOVAL )
  8. REMOVE ENGINE REAR MOUNTING MEMBER  (See REMOVAL  )
  9. REMOVE TRANSFER DYNAMIC DAMPER  (See REMOVAL  )
  10. REMOVE TRANSFER OIL PAN  (See REMOVAL  )
  11. REMOVE TRANSFER VALVE BODY ASSEMBLY  (See REMOVAL  )
  12. REMOVE TRANSFER CONTROL SOLENOID 
    1. Remove the bolt, solenoid lock plate and transfer control solenoid.
      Fig 1: Identifying Bolt For Transfer Control Solenoid
      G05318720Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals