Transfer Case Rear Oil Seal: Replacement

WARNING: This page is about a different variant/trim than selected.

DRAIN AUTOMATIC TRANSMISSION FLUID (See REMOVAL )
REMOVE REAR NO. 1 FLOOR PANEL BRACE (See REMOVAL )
REMOVE FRONT CENTER FLOOR BRACE (See REMOVAL )
REMOVE HEATED OXYGEN SENSOR (See REMOVAL )
REMOVE FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR (See REMOVAL )
REMOVE OUTSIDE AIR GUIDE PLATE RH (See REMOVAL )
REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (See REMOVAL )
REMOVE TRANSFER CASE REAR OIL SEAL
1. Using SST, remove the oil seal.
  SST 09308-00010
  
  Fig 1: Removing Transfer Case Rear Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSFER CASE REAR OIL SEAL
1. Using SST and a hammer, install a new oil seal.
  SST 09325-40010
  
  Oil seal installation depth: 2.3 to 2.7 mm (0.091 to 0.106 in.)
2. Apply MP grease to the oil seal lip.
INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (See INSTALLATION )
INSPECT AND ADJUST BOTH NO. 2 AND NO. 3 JOINT ANGLES (See INSTALLATION )
INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR (See INSTALLATION )
INSTALL OUTSIDE AIR GUIDE PLATE RH (See INSTALLATION )
INSTALL FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL HEATED OXYGEN SENSOR (See INSTALLATION )
INSTALL FRONT CENTER FLOOR BRACE (See INSTALLATION )
INSTALL REAR NO. 1 FLOOR PANEL BRACE (See INSTALLATION )
ADD AUTOMATIC TRANSMISSION FLUID (See ADJUSTMENT )
CHECK FOR EXHAUST GAS LEAKS