LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (UF1AE Transfer Case) >> 4WD Control Ecu >> Removal

4WD Control Ecu: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FRONT DOOR SCUFF PLATE RH (w/o Illumination) 

    HINT:

    Use the same procedures for the RH side and the LH side (See REMOVAL ).

  2. REMOVE FRONT DOOR SCUFF PLATE RH (w/ Illumination) 

    HINT:

    Use the same procedures for the RH side and the LH side (See REMOVAL ).

  3. REMOVE FRONT DOOR OPENING TRIM COVER RH  (See REMOVAL )
  4. REMOVE SIDE INSTRUMENT PANEL RH  (See REMOVAL )
  5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE 4WD CONTROL ECU 
    1. Turn back the front floor carpet assembly.
    2. Disengage the 2 clips and separate the junction connector.
      Fig 1: Connecting Junction Connector With Clips
      G05318807Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt and nut.
      Fig 2: Locating Bolt And Nut
      G05318808Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the clamp and connector, and remove the 4WD control ECU.
      Fig 3: Disconnecting Connector And Clamp
      G05318809Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals