LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (A760H Automatic Transaxle) >> Shift Lever Assembly >> Removal

Shift Lever Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH  (See REMOVAL )
  3. REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH  (See REMOVAL )
  4. REMOVE FRONT ASH RECEPTACLE SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE CONSOLE PANEL SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE CONSOLE BOX REGISTER ASSEMBLY  (See REMOVAL )
  7. REMOVE CONSOLE BOX  (See REMOVAL )
  8. REMOVE NO. 2 CONSOLE BOX DUCT  (See REMOVAL )
  9. REMOVE NO. 1 REAR FLOOR PANEL BRACE  (See REMOVAL )
  10. REMOVE FRONT CENTER FLOOR BRACE  (See REMOVAL )
  11. REMOVE OXYGEN SENSOR  (See REMOVAL )
  12. REMOVE FRONT EXHAUST PIPE ASSEMBLY  (See REMOVAL )
  13. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR  (See REMOVAL )
  14. REMOVE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY 
    1. Remove the nut and separate the floor shift gear shifting rod sub-assembly.
      Fig 1: Locating Nut
      G05317640Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY 
    1. Disconnect the 2 connectors.
    2. Remove the 4 bolts.
    3. Remove the floor shift assembly.
      Fig 2: Locating Connectors And Bolts
      G05318245Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals