LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Steering Column) >> Tilt And Telescopic Manual Switch >> Removal

Tilt And Telescopic Manual Switch: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See PRECAUTION ).
  1. PRECAUTION 

    See PRECAUTION 

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL  (See REMOVAL  )
  4. REMOVE LOWER NO. 3 STEERING WHEEL COVER  (See REMOVAL )
  5. REMOVE LOWER NO. 2 STEERING WHEEL COVER  (See REMOVAL )
  6. REMOVE STEERING PAD  (See REMOVAL )
  7. REMOVE STEERING WHEEL ASSEMBLY  (See REMOVAL  )
  8. REMOVE LOWER STEERING COLUMN COVER 
    1. Remove the 3 screws
    2. Disengage the 2 claws to remove the lower steering column cover.
      NOTE: Do not damage the tilt and telescopic switch.
      Fig 1: Identifying Lower Steering Column Cover Screws
      G05753073Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE TILT AND TELESCOPIC SWITCH 
    1. Disconnect the connector
    2. Disengage the claw and pull out the tilt and telescopic switch
      NOTE: Pushing on the claw too hard will break the claw.
      Fig 2: Locating Tilt And Telescopic Switch Connector
      G05753074Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals