Inspection Procedure
WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING TECHSTREAM (COMBINATION SWITCH)
- Turn the engine switch off
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG)
- Turn the Techstream on.
- Check the tilt and telescopic manual switch Enter the following menus' Body Electrical / Combination Switch / Data List
Combination Switch
DATA LISTTester Display Measurement Item/Range Normal Condition Diagnostic Note Telesc Short SW Telescopic SHORT switch status/ OFF or ON OFF Telescopic short is not activated by manual switch
ON Telescopic short is activated by manual switch- Telesc Long SW Telescopic LONG switch status/OFF or ON OFF Telescopic long is not activated by manual switch
ON Telescopic long is activated by manual switch- Tilt Down SW Tilt DOWN switch status/OFF or ON OFF Tilt down is not activated by manual switch
ON Tilt down is activated by manual switch- Tilt Up SW Tilt UP switch status/OFF or ON OFF Tilt up is not activated by manual switch
ON Tilt up is activated by manual switch- OK: "ON" is displayed on the Techstream screen when each switch is turned on.
"OFF" is displayed on the Techstream screen when each switch is turned off.
NG: REPLACE TILT AND TELESCOPIC SWITCH (See REMOVAL )
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See HOW TO PROCEED WITH TROUBLESHOOTING )