Luggage Compartment Door Support: Installation

HINT

• Use the same procedure for the RH side and LH side.
• The procedure listed below is for the LH side

1. INSTALL LUGGAGE COMPARTMENT DOOR SUPPORT ASSEMBLY 
   NOTE:

   • Avoid touching the stroke portions of the rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinders while servicing.
   • Do not wear cotton gloves or other similar materials when handling the rod. Fibers may attach to the rod and result in gas leaks.
   • Do not apply any load to the cylinders in the horizontal direction in order to prevent the rod from being deformed.
   1. Return the claws on the bracket of the luggage compartment door support.
   2. Install the stop ring to the luggage compartment door support
   3. Engage the luggage compartment door support to the ball joint and the pin.
      NOTE:

      • Install the luggage compartment door support assembly while supporting the luggage compartment door by hand.
      • Check that the luggage compartment door support assembly is engaged in the ball joint and it cannot be pulled out.

      Fig 1: Identifying Ball Joint And Pin

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER  (See INSTALLATION )
3. INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM HOOK  (See INSTALLATION )
4. INSTALL ROPE HOOK  (See INSTALLATION )
5. INSTALL NO. 2 ROOM LIGHT ASSEMBLY  (See INSTALLATION )
6. INSTALL REAR LUGGAGE COMPARTMENT TRIM COVER  (See INSTALLATION )
7. INSTALL ROPE HOOK ASSEMBLY  (See ADJUSTMENT  )
8. INSTALL DECK SIDE TRIM BOX RH 
9. INSTALL DECK SIDE TRIM BOX LH 
10. INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM COVER