Engine Front Oil Seal: Removal

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE RADIATOR ASSEMBLY
HINT:

See REMOVAL .
REMOVE V-RIBBED BELT (See REMOVAL )
REMOVE CRANKSHAFT PULLEY
1. Using SST, loosen the pulley bolt.
  SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05021)
  
  Fig 1: Loosening Pulley Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Tighten the pulley bolt to 2 or 3 threads of the crankshaft.
3. Using SST, remove the pulley bolt and pulley.
  SST 09213-70011 (09213-70020), 09330-00021
  
  HINT:
  
  Apply grease to the threads and tip of the SST (center bolt) prior to use.
  
  Fig 2: Tightening Pulley Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the pulley set key of the key groove.
  
  Fig 3: Identifying Pulley Set Key Of Key Groove
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE TIMING CHAIN CASE OIL SEAL
1. Using a screwdriver with its tip taped, pry out the oil seal.
  HINT:
  
  Tape the screwdriver tip before use.
  
  NOTE: After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.
  
  Fig 4: Prying Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002