Extension Housing Rear Oil Seal: Installation

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL
1. Coat the lip of a new oil seal with MP grease.
  
  Fig 1: Removing Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST and a hammer, drive in the oil seal with the lip facing inside of the automatic transmission.
  SST 09316-60011 (09316-00011, 09316-00051)
  
  Oil seal depth from flat end:
  
  1.8 to 2.2 mm (0.071 to 0.087 in.)
  
  Fig 2: Installing Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AUTOMATIC TRANSMISSION FLANGE YOKE ASSEMBLY
1. Using SST and a hammer, drive in a new oil seal.
  SST 09517-36010
2. Install the automatic transmission flange yoke.
3. Attach the SST.
  SST 09330-00021, 09950-30012 (09955-03040)
  
  Fig 3: Installing Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using SST and a 30 mm socket wrench, install and tighten a new nut.
  Torque: 126 N*m (1,285 kgf*cm, 93 ft.*lbf)
5. Using a chisel and hammer, securely stake the nut.
INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (See INSTALLATION )
INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR (See INSTALLATION )
INSTALL OUTSIDE AIR GUIDE PLATE RH (See INSTALLATION )
INSTALL FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL OXYGEN SENSOR (See INSTALLATION )
INSTALL FRONT CENTER FLOOR BRACE (See INSTALLATION )
INSTALL NO. 1 REAR FLOOR PANEL BRACE (See INSTALLATION )
ADD AUTOMATIC TRANSMISSION FLUID
(See AUTOMATIC TRANSMISSION FLUID )
CHECK FOR EXHAUST GAS LEAKS (See INSTALLATION )