Front Seat Outer Belt Assembly With PRETENSIONER: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT FRONT SEAT OUTER BELT ASSEMBLY
1. Check the degree of tilt when the ELR begins to lock.
  1. Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the belt.
    NOTE: Do not disassemble the retractor.
    
    Fig 1: Checking Degree Of Tilt When ELR Begins To Lock
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT SEAT OUTER BELT ASSEMBLY
1. Temporarily install the front seat outer belt assembly with the 2 bolts.
2. Fully tighten the upper side bolt first, then the lower side bolt to install the front seat outer belt assembly.
  Torque:
  
  For upper bolt
  
  7.5 N*m (77 kgf*cm, 66 in.*lbf)
  
  For lower bolt
  
  42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  Fig 2: Identifying Front Seat Outer Belt Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the pretensioner connector and lock the locking button as shown in the illustration
  NOTE: Securely lock the locking button.
4. Connect the connectors
  
  Fig 3: Connecting Pretensioner Connector And Lock Locking Button
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Install the shoulder anchor of the front seat outer belt assembly with the nut.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  Fig 4: Identifying Shoulder Anchor Nut Of Front Seat Outer Belt Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CENTER PILLAR GARNISH (See INSTALLATION )
INSTALL LOWER CENTER PILLAR GARNISH (See INSTALLATION )
INSTALL REAR DOOR SCUFF PLATE (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE (See INSTALLATION )
CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH (for LH Side) (See INSTALLATION )
INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH (for RH Side) (See INSTALLATION )
INSTALL LAP BELT OUTER ANCHOR COVER LH (for LH Side) (See INSTALLATION )
INSTALL FRONT SEAT BELT ANCHOR COVER SUB-ASSEMBLY (for RH Side) (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).