POWER WINDOW REGULATOR MOTOR (for Rear Door): Removal
WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See PRECAUTION ).NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
- REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG (See DISASSEMBLY )
- REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (See DISASSEMBLY )
- REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY (See DISASSEMBLY )
- REMOVE REAR DOOR INNER GLASS WEATHERSTRIP (See DISASSEMBLY )
- REMOVE REAR DOOR SERVICE HOLE COVER (See DISASSEMBLY )
- REMOVE REAR DOOR GLASS RUN (See DISASSEMBLY )
- REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY (See DISASSEMBLY )
- REMOVE REAR DOOR QUARTER WINDOW GLASS (See DISASSEMBLY )
- REMOVE REAR DOOR GLASS SUB-ASSEMBLY (See DISASSEMBLY )
- REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (See DISASSEMBLY )
- REMOVE REAR POWER WINDOW REGULATOR MOTOR
- Using a "TORX" socket wrench (T25), remove the 3 screws and the rear power window regulator motor