LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Wiper & Washer) >> Headlight Cleaner Actuator >> Installation

Headlight Cleaner Actuator: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY 
    1. Engage the 2 claws.
    2. Install the headlight washer actuator sub-assembly with the bolt
    3. Connect the hose joint and the headlight cleaner hose

      HINT

      Use the same procedure for the RH side and LH side

      Fig 1: Locating Headlight Washer Actuator Sub-Assembly With Bolt
      G05756350Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL HEADLIGHT CLEANER WASHER NOZZLE  (See INSTALLATION  )
  3. INSTALL FRONT BUMPER ASSEMBLY  (See INSTALLATION )
  4. ADD WASHER FLUID  (See INSTALLATION  )
  5. INSTALL RADIATOR GRILLE PROTECTOR  (See INSTALLATION )
  6. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  7. VEHICLE PREPARATION FOR FOG LIGHT AIMING ADJUSTMENT  (See ADJUSTMENT )
  8. PREPARATION FOR FOG LIGHT AIMING  (See ADJUSTMENT )
  9. INSPECT FOG LIGHT AIMING  (See ADJUSTMENT )
  10. ADJUST FOG LIGHT AIMING  (See ADJUSTMENT )
scientia non olet · About LEMON Manuals