Instrument Panel Safety Pad: Disassembly
WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE NO. 1 HEATER TO REGISTER DUCT
- Remove the 3 screws < E > and the No. 1 heater to register duct.
- REMOVE NO. 3 HEATER TO REGISTER DUCT
- Remove the 3 screws < E > and the No. 3 heater to register duct.
- REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT
- Remove the screw < E > and the side No 1 defroster nozzle duct.
- REMOVE SIDE NO. 2 DEFROSTER NOZZLE DUCT
- Remove the screw < E > and the side No. 2 defroster nozzle duct
- REMOVE DEFROSTER NOZZLE ASSEMBLY
- Remove the 3 screws < E > and the defroster nozzle assembly
- REMOVE NO. 2 HEATER TO REGISTER DUCT
- Remove the 4 screws < E > and the No. 2 heater to register duct
- REMOVE SIDE DEFROSTER NOZZLE
- Disengage the 4 claws and remove the side defroster nozzle
- REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (See REMOVAL )
- REMOVE NAVIGATION ANTENNA ASSEMBLY (See REMOVAL )
- REMOVE NO. 2 INSTRUMENT PANEL WIRE
- Disconnect the connector
- Disengage the 5 clamps and remove the No 2 instrument panel wire.
- REMOVE FRONT PASSENGER AIRBAG ASSEMBLY (See REMOVAL )
- REMOVE DEFROSTER NOZZLE GARNISH
- Disengage the 8 claws and 2 clips, and then remove the defroster nozzle garnish
- REMOVE AUTOMATIC LIGHT CONTROL SENSOR
- Disengage the 2 claws and remove the automatic light control sensor
- REMOVE ENGINE SWITCH
- Disengage the 2 claws and remove the engine switch
- REMOVE INSTRUMENT PANEL SPACER
- Remove the instrument panel spacer.
- REMOVE NO. 1 INSTRUMENT PANEL PIN
- Remove the 4 screws < E > and the 4 No 1 instrument panel pins.