LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Park Assist / Monitoring) >> ULTRASONIC SENSOR (for Rear Side) >> Removal

ULTRASONIC SENSOR (for Rear Side): Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE LUGGAGE COMPARTMENT TRIM COVER 
  2. REMOVE DECK SIDE TRIM BOX LH 
  3. REMOVE DECK SIDE TRIM BOX RH 
  4. REMOVE ROPE HOOK ASSEMBLY  (See REMOVAL )
  5. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER  (See REMOVAL )
  6. REMOVE NO. 2 ROOM LIGHT ASSEMBLY  (See REMOVAL )
  7. REMOVE ROPE HOOK  (See REMOVAL )
  8. REMOVE NO. 2 LUGGAGE COMPARTMENT TRIM HOOK  (See REMOVAL )
  9. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER  (See REMOVAL )
  10. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK  (See REMOVAL )
  11. REMOVE SIDE LUGGAGE COMPARTMENT TRIM COVER  (See REMOVAL )
  12. REMOVE NO. 1 REAR BUMPER PLATE  (See REMOVAL )
  13. REMOVE REAR BUMPER ASSEMBLY  (See REMOVAL )
  14. REMOVE NO. 2 ULTRASONIC SENSOR 
    1. Disconnect the sensor connector
    2. Remove the sensor retainer as shown in the illustration
    3. Remove the No 2 ultrasonic sensor from the rear bumper
      4. Fig 1: Removing No. 2 Sensor Retainer
      G05753877Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE NO. 1 ULTRASONIC SENSOR 
    1. Disconnect the sensor connector
    2. Remove the sensor retainer as shown in the illustration
    3. Remove the No 1 ultrasonic sensor from the rear bumper
      Fig 2: Removing No. 1 Sensor Retainer
      G05753872Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals