LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Park Assist / Monitoring) >> ULTRASONIC SENSOR (for Front Side) >> Installation

ULTRASONIC SENSOR (for Front Side): Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL NO. 1 ULTRASONIC SENSOR 
    1. Install the No 1 ultrasonic sensor to the front bumper.
    2. Install the sensor retainer as shown in the illustration
    3. Connect the sensor connector
      4. Fig 1: Installing Sensor Retainer
      G05300010Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT BUMPER ASSEMBLY  (See INSTALLATION )
  3. INSTALL RADIATOR GRILLE PROTECTOR  (See INSTALLATION )
  4. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  5. ADD WASHER FLUID (w/ Headlight Cleaner System)  (See INSTALLATION )
  6. VEHICLE PREPARATION FOR FOG LIGHT AIMING ADJUSTMENT  (See ADJUSTMENT )
  7. PREPARATION FOR FOG LIGHT AIMING  (See ADJUSTMENT )
  8. INSPECT FOG LIGHT AIMING  (See ADJUSTMENT )
  9. ADJUST FOG LIGHT AIMING  (See ADJUSTMENT )
scientia non olet · About LEMON Manuals