LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Fuel) >> Fuel Sender Gauge Assembly >> Installation

Fuel Sender Gauge Assembly: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. Install the fuel sender gauge assembly by sliding it downward
      NOTE: Do not damage the wire harness.
    2. Connect the connector of the fuel sender gauge assembly
    Fig 1: Locating Fuel Sender Gauge Assembly
    G05750079Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE: Make sure that the fuel sender gauge arm does not bend.
  2. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY  (See INSTALLATION )
  3. INSTALL FUEL SENDER GAUGE  (See INSTALLATION )
  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  5. INSPECT FOR FUEL LEAK  (See ON-VEHICLE INSPECTION )
  6. INSTALL REAR FLOOR SERVICE HOLE COVER  (See INSTALLATION )
  7. INSTALL NO. 2 REAR FLOOR SERVICE HOLE COVER  (See INSTALLATION )
  8. INSTALL NO. 3 ROOM PARTITION PAD  (See INSTALLATION )
  9. INSTALL REAR SEAT CUSHION ASSEMBLY  (See INSTALLATION )
scientia non olet · About LEMON Manuals