Rear Axle Carrier: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.

INSTALL REAR AXLE CARRIER SUB-ASSEMBLY
1. Hold the rear axle carrier sub-assembly between aluminum plates in a vise.
  NOTE: Do not overtighten the vise.
2. Install the parking brake anchor block, cable support bracket and parking brake plate with the 2 nuts.
  Torque: 76 N*m (775 kgf*cm, 56 ft.*lbf)
Fig 1: Locating Rear Axle Hub Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (See INSTALLATION )
INSTALL REAR NO. 2 WHEEL BEARING DUST DEFLECTOR (See INSTALLATION )
INSTALL REAR AXLE ASSEMBLY
HINT:

Refer to the procedure from Install Rear Axle Assembly (See INSTALLATION ).